RWD Limited Slip Differential Installation Specs

Helical LSD's & Metal Plate LSD's
Locked
User avatar
YCW
Site Admin
Posts: 11
Joined: Sat Feb 25, 2017 5:59 pm
Location: San Dimas, CA / Taichung, TW
Contact:

RWD Limited Slip Differential Installation Specs

Post by YCW » Sun Feb 26, 2017 2:01 am

- Measure back lash and bearing preload and mark the OEM C-Clips prior to removal so they can be reinstalled on the same side during reassembly
- Bolt ring gear to LSD @ 80 ft. lbs. torque (E92 LSD) or 70 ft. lbs. (E46 LSD)
- Press bearing races on LSD
- Install LSD with bearings into housing using the OEM C-Clips
- Measure backlash (0.003” – 0.009” acceptable)
- Measure bearing preload (2-10 inch lbs. acceptable)
- Check with marking compound for acceptable gear pattern

If backlash needs adjustment, install shims under bearing races with thinner replacement C-Clip

Please Contact Us for replacement Bearings & Shim Kits
MFactory / YCW Engineering (LSD's, Gears, Flywheels, Clutches, Driveshafts, Axles) - http://www.teammfactory.com
YCW Suspension (Mid-Range Coilovers) - http://www.ycwsuspension.com
SWIFT Springs Europe (Exclusive Distributor) - http://www.swiftspringseurope.com
SWIFT Springs Asia (Exclusive Distributor) - http://www.swiftspringsasia.com

Locked

Who is online

Users browsing this forum: No registered users and 2 guests